User Guide

ManualsBrandsASUS ManualsOtherTS100-E3PI2

ASUS TS100-E3ASUS TS100-E3

ASUS TS100-E3

4-154-15

4-15

Block (Multi-sector Transfer) [Auto]Block (Multi-sector Transfer) [Auto]

Block (Multi-sector Transfer) [Auto]

Enables or disables data multi-sectors transfers. When set to [Auto], the

data transfer from and to the device occurs multiple sectors at a time if the

device supports multi-sector transfer feature. When set to [Disabled], the

data transfer from and to the device occurs one sector at a time. Configuration

options: [Disabled] [Auto]

PIO Mode [Auto]PIO Mode [Auto]

PIO Mode [Auto]

Selects the PIO mode. Configuration options: [Auto] [0] [1] [2] [3] [4]

DMA Mode [Auto]DMA Mode [Auto]

DMA Mode [Auto]

Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1]

[SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]

[UDMA3] [UDMA4] [UDMA5] [UDMA6]

SMART Monitoring [Auto]SMART Monitoring [Auto]

SMART Monitoring [Auto]

Sets the Smart Monitoring, Analysis, and Reporting Technology.

Configuration options: [Auto] [Disabled] [Enabled]

32Bit Data Transfer [Enabled]32Bit Data Transfer [Enabled]

32Bit Data Transfer [Enabled]

Enables or disables 32-bit data transfer.

Configuration options: [Disabled] [Enabled]

4.3.54.3.5

4.3.5

IDE ConfigurationIDE Configuration

IDE Configuration

Configure SATA As [Standard IDE]

Onboard IDE Operate Mode [Enhanced Mode]

Enhanced Mode Support On [S-ATA]

IDE Detect Time Out (Sec) [35]

BIOS SETUP UTILITY

Main

When in AHCI/RAID

mode SATA controller

is forced to Native

mode.

The items in this menu allow you to set or change the configurations for the

IDE devices installed in the system. Select an item then press <Enter> if you

want to configure the item.

Configure SATA as [Standard IDE]Configure SATA as [Standard IDE]

Configure SATA as [Standard IDE]

If you want the Serial ATA hard disk drives to use the Advanced Host Controller

Interface (AHCI), set this item to [AHCI]. The SATA controller is set to Native

mode when this item is set to [RAID] or [AHCI]. Configuration options:

[Standard IDE] [AHCI] [RAID]