User Guide

3-133-13

3-13

ASUS TS100-E3ASUS TS100-E3

ASUS TS100-E3

6.6.

Serial port connector (10-1 pin COM2)Serial port connector (10-1 pin COM2)

Serial port connector (10-1 pin COM2)

This connector is for a serial (COM) port. Connect the serial port module

cable to this connector, then install the module to a slot opening at the

back of the system chassis. The serial port module is purchased

separately.

7.7.

Chassis intrusion connector (4-1 pin CHASSIS1)Chassis intrusion connector (4-1 pin CHASSIS1)

Chassis intrusion connector (4-1 pin CHASSIS1)

This connector is for a chassis-mounted intrusion detection sensor or

switch. Connect one end of the chassis intrusion sensor or switch cable

to this connector. The chassis intrusion sensor or switch sends a high-

level signal to this connector when a chassis component is removed or

replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted

with a jumper cap. Remove the jumper caps only when you intend to use

the chassis intrusion detection feature.

P5MT-MX/C Serial Port (COM2) Connector

PIN 1

COM2



®

P5MT-MX/C

P5MT-MX

P5MT-MX/C Chassis intrusion connector

GND

(Default)

Chassis Signal

+5VSB_MB

CHASSIS1