User’s Manual

10
Single Board Computer
2.1 Before you proceed
Take note of the following precautions before you install your Single Board Computer components or change
any single board computer settings.
NOTE: The diagrams in this chapter are for reference only. The Single Board Computer layout may vary
with models.
IMPORTANT! Components shown in this section may be purchased separately. Refer to Package contents
section for more information about the contents of your Single Board Computer package.
WARNING!
• Unplug the power cord from the wall socket before touching any component.
• Before handling components, use a grounded wrist strap or touch a safely grounded object or a metal
object, such as the power supply case, to avoid damaging them due to static electricity.
• Hold components by the edges to avoid touching the ICs on them.
• Whenever you uninstall any component, place it on a grounded antistatic pad or in the bag that came
with the component.
• Before you install or remove any component, ensure that the power supply is switched off or the power
cord is detached from the power supply. Failure to do so may cause severe damage to the single board
computer, peripherals, or components.