Specifications

Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setup
2-162-16
2-162-16
2-16
5. Connect the IDE cable to the IDE
connector on the back of the
drive.
6. Connect a 4-pin plug from the
power supply to the power
connector on the back of the
drive.
IDE cableIDE cable
IDE cableIDE cable
IDE cable
Power plugPower plug
Power plugPower plug
Power plug
3. Make sure that the drive and
bay hole align as shown. When
in place, the drive protrudes
about an inch from the front
panel.
4. Secure the drive with a screw.