User Guide

ASUS Terminator K7 Barebone System 43

3. USB Device Wake Up (Front and Back Panel USB Ports).

Set these jumpers to +5V to allow wake up from S1 sleep state

(CPU stopped; RAM refreshed; system running in low power

mode) using the connected USB devices. Set to +5VSB to allow

wake up from S3 state (no power to CPU; RAM in slow refresh;

power supply in reduced power mode).

A7VC

A7VC CPU FSB Frequency Setting

CPU 133MHz

12 2

FS1 & FS2

CPU 100MHz

2. CPU/FSB Frequency Selection. The FS jumper is set to a

factory default [2-3] that operates with AMD 100 MHz FSB

capacity processors. If AMD 133 MHz capacity processors are

used, then reset the jumper to [1-2]. The FS jumper settings

should match the capacity of the processor. Otherwise, the

motherboard may not boot up.

A7VC

A7VC USB Ports Setting

(Back Panel USB Port)

JP1A

+5V

+5VSB

(Front Panel USB Port)

JP1B

+5V

+5VSB