User Guide

ASUS PCI-SC875 User’s Manual 27
V. DOS/WINDOWS DRIVERS
V. DOS/WINDOWS
(Troubleshooting)
b. Does the SCSI BIOS see the bootable SCSI drive?
NOTE: When the computer boots, SDMS scans the SCSI bus. Devices found
on the SCSI bus are identified as in the following lines:
HBA ID LUN VENDOR PRODUCT REV ....
0 2 0 SEAGATE ST31230N 0060 ....
0 7 0 Symbios SYM53C875 0003 ....
YES Go to c.
NO Power down all units in the system.
Make sure the hard drives have different ID numbers (boot drive
should have lowest ID).
Make sure both ends of the SCSI bus are terminated.
Check all cable and power connections.
Check CMOS setup.
Boot system.
Go to a.
c. If boot is still unsuccessful, go to the following item.
THE DEVICE DRIVER DOES NOT RECOGNIZE ONE OF THE NON-BOOT
SCSI PERIPHERALS (system may lock up)
a. Make sure the drivers were installed in the correct sequence.
b. Make sure the drivers’ CONFIG.SYS line has the correct path to the drivers.
c. Power down all units in the system.
d. Make sure the hard drives have different ID numbers (boot drive should have
lowest ID).
e. Make sure both ends of the SCSI bus are terminated.
f. Check all cable and power connections.
g. Boot the system.