User Guide

12 ASUS PCI-SC875 User’s Manual
IV. CONFIGURATION
Main Menu
When you start the Symbios Logic Configuration Utility, your computer monitor
displays the Main menu. This menu is your entry to the utility.
The Main menu displays a list of up to four Symbios Logic PCI to SCSI host adapt-
ers in you system, and information about each of them.
By using the arrow keys, an adapter is selected to view and/or change current set-
tings for the adapter, and the SCSI devices attached to it. An adapter is selectable
only if the current status is “On”. Changes are possible only if NvRAM (non-vola-
tile memory on your adapter) is present.
Following the list of host adapters on the Main menu display, you see the options
described below. If these settings are altered, the system reboots upon exit from the
configuration utility by the Quit option.
Adapter Boot Order - allows you to set the order in which host adapters boot when
you have more than one Symbios Logic host adapter in your system. When this
option is selected, the Boot Order menu is shown.
To change an apapter’s boot order, select it and press Enter. You are then prompted
to enter the new boot sequence number. When the adapters are ordered properly,
press the Escape key to exit this menu.
Change Adapter Status - allows you to activate or deactivate a host adapter and all
SCSI devices attached to it. The change takes place after a reboot, which is auto-
matic upon exit from the utility when this option is used to make a change. When
this option is selected the Change Status menu is displayed.
To change an adapter’s status, select it and press Enter. Then press the escape key
to exit this menu.
Display Mode - determines how much information about your host adapter(s) and
SCSI devices is displayed on your computer monitor during boot. For more com-
plete information, choose the verbose setting. For a faster boot, choose the terse
setting.
Mono/Color - allows you to choose between a black and white or color display for
the SCSI Configuration utility. You might need to choose the mono setting to get a
more readable screen on a black and white monitor.
Help - brings up a help screen with information about the Main menu.
Quit - gets you out of the SCSI Configuration utility.
IV. CONFIGURATION
(Main Menu)