User's Manual
Table Of Contents
- Safety information
- Product introduction
- Basic Installation
- BIOS setup
- Software support
- RAID support
- Multiple GPU support
- Appendices
ASUS SABERTOOTH 990FX R2.0
1-31
Chapter 1
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
You can connect the front panel USB cable to the ASUS Q-Connector (USB, blue) rst, and
then install the Q-Connector (USB) to the USB connector onboard if your chassis supports
front panel USB ports.
The USB 2.0 module is purchased separately.
5. USB 2.0 connectors (10-1 pin USB1314, USB1112)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specication that supports up to
48 MBps connection speed.
++E8042_SABERTOOTH_990FX_R2.0_V231 31 9/1/13 3:34:00 PM