User’s Manual
Table Of Contents
- About this guide
- Notices
- Safety information
- Chapter 1: Product introduction
- Chapter 2: Hardware setup
- Chapter 3: Installation options
- Chapter 4: Motherboard information
- Chapter 5: BIOS setup
- Chapter 6: RAID configuration
- Chapter 7: Driver installation
2-23ASUS RS720QA-E6/RS12, RS724QA-E6/RS12
9. Remove the SATA/SAS cables from
the onboard SATA1–3 connectors.
10. Connect the SATA/SAS cables
to the SAS1–3 connectors on the
PIKE riser card.
13. Ensure that the
SGPIO_SEL
jumper in front of the server node is
set to pin 2–3.
11. Align the riser card bracket to
the PCI Express x16 slot on the
motherboard.
12. Press the riser card bracket until
the golden ngers completely t the
slot and the bracket aligns with the
rear panel.