User’s Manual
Table Of Contents
- About this guide
- Notices
- Safety information
- Chapter 1: Product introduction
- Chapter 2: Hardware setup
- Chapter 3: Installation options
- Chapter 4: Motherboard information
- Chapter 5: BIOS setup
- Chapter 6: RAID configuration
- Chapter 7: Driver installation
Chapter 2: Hardware setup2-16
2.6 Cable connections
Pre-connected system cables
1. 20-pin proprietary power connector (from power supply to motherboard)
2. 4-pin proprietary power connector (from power supply to motherboard)
3. System fan connectors (from motherboard FRNT_FAN1, FRNT_FAN2,
FRNT_FAN3 and FRNT_FAN4 to system fans)
4. Panel connector (from motherboard to front I/O board)
5. SATA connectors (from motherboard to SATAII/SAS backplane board)
6. Auxiliary panel connector (from motherboard to front I/O board)
• The bundled system cables are pre-connected before shipment. You do
not need to disconnect these cables unless you will remove pre-installed
components to install additional devices.
• Refer to Chapter 4 for detailed information on the connectors.
RS720QA-E6/RS12 (KGNH-D16) RS724QA-E6/RS12 (KGMH-D16/QDR)
1
2
3
3
3
4
5
6
3
1
2
3
3
3
4
5
6
3