User’s Manual
Table Of Contents
- About this guide
- Notices
- Safety information
- Chapter 1: Product introduction
- Chapter 2: Hardware setup
- Chapter 3: Installation options
- Chapter 4: Motherboard information
- Chapter 5: BIOS setup
- Chapter 6: RAID configuration
- Chapter 7: Driver installation
Chapter 2: Hardware setup2-22
5. Secure the PIKE riser card to the
riser card bracket with two screws.
6. Align and insert the golden ngers
of the PIKE SAS RAID card into
the card slot on the PIKE raiser
card. Ensure the card is completely
seated on the slot.
7. Detach the SGPIO cable from the
SGPIO1 connector near DIMM slot
A2 (blue).
8. Connect the SGPIO cable to the
SGPIO connector on the PIKE
Riser card.