User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-20
Chapter 4: BIOS Setup
NTB Common Options
Socket-0 P0/Socket-0 P2/Socket-0 G0/Socket-0 G2
NTB Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
The following items appear only when NTB Enable is set to [Enabled].
Start Lane
Allows you to set the NTB start lane.
End Lane
Allows you to set the NTB end lane.
Link Speed [Auto]
Allows you to set the NTB Link Speed
Configuration options: [Gen1] [Gen2] [Gen3] [Gen4] [Gen5] [Auto]
SOC Miscellaneous Control
ABL Console Out Control [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
The following items appear only when ABL Console Out Control is set to [Enabled].
ABL Console Out Serial Port [Auto]
Configuration options: [eSPI UART] [SOC UART0] [SOC UART1] [Auto]
ABL Console Out Serial Port IO [Auto]
Configuration options: [0x3F8] [0x2F8] [0x3E8] [0x2E8] [Auto]
ABL Basic Console Out Control [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
ABL PMU Message Control [Auto]
Allows you to control the number of PMU debug messages.
Configuration options: [Detailed debug messages] [Coarse debug messages]
[Stage completion] [Assertion messages] [Firmware completion messages
only] [Auto]
ABL Memory Population Message Control [Warning Message]
Configuration options: [Warning Message] [Fatal Error]
PSP Error Injection Support [False]
Configuration options: [False] [True]
Firmware Anti-rollback (FAR)
Allows you to configure Firmware Anti-Rollback (FAR) options.