User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
2-25
RS720QA-E12-RS8U
1. Remove the screw securing the M.2 baseboard from the motherboard, then lift and
remove the M.2 baseboard.
2.6.3 Installing an M.2 card
The illustrations in this section are for reference only. The M.2 card may differ depending
on the M.2 card you purchased.
The
M.2_SLOT1
slot on the motherboard does not support hot-plug. If you wish to install
or remove the M.2 baseboard and/or M.2 card, make sure to power off the system before
installing or removing the M.2 baseboard and/or M.2 card.
2. (optional) To change the position of the tool-less retaining clip for M.2 cards of different
lengths, please refer to the below instructions:
a. Rotate the tool-less retaining clip 90 degrees to unlock it.
b. Remove the tool-less retaining clip from the M.2 baseboard.