User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
Chapter 2: Hardware Information
2-22
To install a PCIe expansion card to the right riser card:
1. Please refer to steps 1 to 2 in the previous section to remove the left riser card.
2. Remove the two (2) screws securing the right riser card to the chassis.
3. Firmly hold the right riser card, then pull it up to detach it from the PCIe x16 slot on the
motherboard.
4. Remove the metal bracket from the riser card.
5. Prepare the expansion card.
Before installing an expansion card, read the documentation that came with it and ensure to
make the necessary hardware settings.
6. Align and insert the golden finger connectors of the expansion card to the PCIe slot
connector on the riser card as shown.