User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
2-19
RS720QA-E12-RS8U
3. Follow step 4 of the
Installing a 2.5” hot-swap SATA/SAS/NVMe storage device
section to install the storage device and drive tray assembly into the drive bay.
2.5.2 Removing a 2.5” hot-swap SATA/SAS/NVMe storage
device
1. Follow steps 1 and 2 of the
Installing a 2.5” hot-swap SATA/SAS/NVMe storage
device
section to remove the drive tray.
2. Push the 2.5” storage device through the openings on the bottom of the tray until the 2.5”
storage device pops out of the tray.
DO NOT touch the circuit board on the 2.5” storage device. Ensure to push the 2.5” storage
device through the opening on the bottom of the tray.