User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-16
PCIe Ten Bit Tag Support [Auto]
Allows you to enable PCIe ten bit tags for supported devices. Support is disabled if this
option is enabled.
Configuration options: [Disabled] [Enabled] [Auto]
SMU Common Options
Allows you to configure SMU Common options.
NBIO RAS Common Options
Allows you to configure NBIO RAS Common options.
Enable AER Cap [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Early Link Speed [Auto]
Configuration options: [Gen1] [Gen2] [Auto]
Hot Plug Handling Mode [Auto]
Configuration options: [OS First] [Firmware First] [System Firmware Intermediary]
[Auto]
Hot Plug Allow FF in Synchronous [Disabled]
Configuration options: [Disabled] [Enabled]
Presence Detect Select Mode [Auto]
Configuration options: [OR] [AND] [Auto]
Data Link Feature Cap [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
CV Test [Auto]
Allows you to enable or disable support for PCIECV tool. Hardware defaults are
preserved if this option is set to Auto.
Configuration options: [Disabled] [Enabled] [Auto]
SEV-SNP Support [Disabled]
Configuration options: [Disabled] [Enabled] [Auto]
Allow Compliance [Auto]
Allows you to enable or disable PCIe RP entering the polling compliance state.
SRIS [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Multi Upstream Auto Speed Change [Auto]
Configuration options: [Disabled] [Enabled] [Auto]