User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-13
MCA Error Threshold Enable [Auto]
Configuration options: [False] [True] [Auto]
MCA FruText [True]
Configuration options: [False] [True]
SMU and PSP Debug Mode [Auto]
If this option is enabled, uncorrected errors detected by the PSP FW or SMU FW will
hang and not reset the system instead of causing a cold reset.
Configuration options: [Disabled] [Enabled] [Auto]
PPIN Opt-in [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
SNP Memory (RMP Table) Coverage [Auto]
Configuration options: [Disabled] [Enabled] [Custom] [Auto]
The following item appears only when SNP Memory (RMP Table) Coverage is set to
[Custom].
Amount of Memory to Cover [10]
Allows you to set the amount of system memory (MB) to be covered in hex.
SMEE [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Action on BIST Failure [Auto]
Allows you to configure what action is taken when a CCD BIST failure is detected.
Configuration options: [Do nothing] [Down-CCD] [Auto]
Enhanced REP MOVSB/STOSB (ESRM) [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Log Transparent Errors [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
AVX512 [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
MONITOR and MWAIT Disable [Auto]
When this option is enabled, MONITOR, MWAIT, MONITORX, and MWAITX opcodes
become invalid.
Configuration options: [Disabled] [Enabled] [Auto]
Small Hammer Configuration [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Corrector Branch Predictor [Disabled]
Configuration options: [Disabled] [Enabled]
PAUSE Delay [Auto]
Configuration options: [Auto] [Disabled] [16 cycles] [32 cycles] [64 cycles] [128 cycles]