User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
2-21
2.6 Expansion slots
The following subsections describe the slots and expansion cards that they support.
Make sure to unplug the power supply before adding or removing expansion cards. Failure
to do so may cause you physical injury and damage motherboard components.
2.6.1 Installing a PCIe expansion card
The onboard PCI Express slots on the motherboard comes pre-installed with two riser cards
that each support one x16 slot (Gen5 x16 link) for installing low profile PCIe x16 cards.
To install a PCIe expansion card to the left riser card:
1. Remove the two (2) screws securing the left riser card to the chassis.
2. Firmly hold the left riser card, then pull it up to detach it from the PCIe x16 slot on the
motherboard.
3. Remove the metal bracket from the riser card.