User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
2-4
2.2 Server node
Hold the server node lever and press the green node latch, then pull the server node out of
the server chassis.
2.2.1 Removing a server node
Align the node with the node slot on the chassis, then push the node all the way into the node
slot.
Visually confirm that the server node is fully inserted into the chassis after installing the
server node. The edges of the server node should be aligned with the edges of the chassis.
2.2.2 Installing a server node
When removing a server node, do not hold onto the handles of other server nodes to
reduce the risk of injury.