User Guide

Chapter 2: Hardware setup
2-2
2.1 Chassis cover
2.1.1 Removing the rear cover
1. Loosen the two screws on the rear panel to release the rear cover from the chassis.
There's no need to remove the screws, just loose them.
2. Use a screwdriver to remove 2 screws at two sides.
3. Push the cover backward to release it from the chassis.
4. Remove the rear cover from the chassis.
The chassis is covered with a layer of lm. Before starting up the system, remove the lm
to avoid overheating.
1
1
2
3
2
2
2