User Guide

ASUS RS162-E4/RX4
2-31
2.8.5 SAS/SATA2 Backpanel and Bridge Card
Follow the steps below to remove/install SAS/SATA2 Backplane and the
Bridge Card.
1. Remove the top cover panel,
then disconnect the 8-pin power
cord to the SAS/SATA2 rear
panel.
To remove the bridge card and and SAS/SATA Backplane:
2. Disconnect the fan cables to the
rear panel.
3. Using a screw driver to remove
the screws on the cover of the
bridge card.
4. Remove t he cov er pan el to
expose the bridge card that
connects SAS/SATA2 rear panel
and the system board.