User Guide

Chapter 2: Hardware setup2-2
2.1 Chassis cover
2.1.1 Removing the front cover
1. Use a Phillips screwdriver to remove
the screw on each front end of the
top cover.
3. Firmly hold the cover and slide it
toward the rear panel for about half
an inch until it is disengaged from the
chassis.
2. Loosen the two thunbscrews on the
rear panel to release the top cover
from the chassis.
4. Release a drive tray by pushing the
spring lock to the right. Then, rmly
hold the tray level and pull all the
drive trays out of the bay.