User's Manual
Table Of Contents
- Accessory Kit Contents
- Installation Guide
- Remove the Side Panels
- Multifunction Cover
- Install The Power Supply Unit (PSU)
- Install the Cooler & RAM on the Motherboard
- Install the Motherboard Unit
- Install the PCI-E Card
- Attach the Front I/O Connectors
- Sync Case Lighting With Addressable RGB Compatible Motherboards
- Extension Hub
- Install the 3.5"/ 2.5" Drives
- Installation and Maintenance of the Dust Filters
- Pump Installation
- GPU Water Block
- Additional Information
- Safety Information
15
Extension Hub
Connect to Front I/O
ARGB header
Connect to Front
I/O PCBA USB 2.0
SATA Power:
Connect to PSU
USB 2.0:
Dedicated USB connection for the ROG Ryujin 240mm AIO Cooler OLED
or other OLED integrated AIO Coolers.
NOTE: This connector is for the AIO Cooler OLED and should not be connected to the Front
I/O USB 2.0 connector.
Connect to ARGB Fan / LED Strip
Connect to 4-pin PWM fan
Connect to 4-pin PWM fan
Connect to
motherboard
4-pin PWM
fan header
SATA Power:
Connect to PSU
擴展集線器 | 扩展集线器 | Prostor pro zapojení | Hub d’extension | Erweiterter Hub | Hub di estensione | 拡張ハブ | 확장
허브 | Hub rozszerzeń | Hub de extensão | Концентратор | Concentrador de extensión | Anslutningshubb | Genişletme
Göbeği | | תובחרה זראמ
Front I/O panel
Connect to MB
ARGB header
(AURA Sync)
* The maximum output of PWM Fan connector is 2.6A.
* The maximum output of LED Strip connector is 2.6A.