User Guide

1-4
Chapter 1: Product Introduction
1.3 Attaching the Stand
1. Remove the input/output port cover from the rear of the monitor. Then
remove the Allen wrench from the cover.
2. Replace the input/output port cover. Then align and install the stand
onto its slot.
3. Using the Allen wrench, secure the stand with the four (4) M6 x
15mm screws.
2
3
1
• We recommend that you cover the table surface with soft
cloth to prevent damage to the monitor
1.3.1 Cable Management
You can organize the cables with the help of the input/output port cover.
• Arranging the cables