User Guide

3-8
Chapter 3: General Instruction
• Power Setting:Selectthepowersettingmode.
IfthesettingissettoStandard Mode,itmayresultinhigherpower
consumption.Ontheotherhand,ifthesettingissettoPower
Saving Mode, it may cause limited luminance performance.
Power Setting
Standard mode setting may result in higher
power consumption. Power saving mode may
cause limited luminance performance.
Would you like to switch to Standard mode?
NO
YES
• OSD Setup:ConfiguretheOSDmenurelatedsettings.
• OSD Position:SettheOSDmenuposition.
• OSD Timeout:AdjusttheOSDtimeout.
• Transparency:AdjusttheOSDbackgroundfromopaqueto
transparent.
• DDC/CI:Enable/DisabletheDDC/CIfunction.
• Screen Protection:Configurethescreensaverrelatedset
up.Youcanimprovetheimagequalityissuesrelatedtoimage
retention when the screen is on for a certain amount of time.
• Screen Saver:Enable/disablethescreensaverfunction.The
screenbrightnesswillautomaticallydecreasewhenthereisno
changeonthescreen.
• Pixel Cleaning:Itcalibratesanyissuesthatmayariseonthe
screenwhenyourmonitorhasbeenturnedonforalongtime.
The process will take approximately 6 minutes. This function
will automatically activate when the monitor is turn off. Do not
unplugthepowercordwhileitisinprogress.Ifyoupoweron
themonitor,thePixelCleaningwillstopoperating.
• Pixel Cleaning Reminder:Enableordisabledisplayingpixel
cleaningreminder.
• Screen Move:Selectthescreenmovementleveltoprevent
imagestickingonthedisplaypanel.
• Adjust Logo Brightness:Enablethisfunctiontoallowthe
systemtoautomaticallyadjustthelogobrightnesstocorrect
the potential picture quality issues.
• DisplayPort Stream:SelectDisplayPort1.2orDisplayPort1.4
accordingtothegraphiccardDPversion.
• DSC Support:Enable/DisabletheDSC(DisplayStream
Compression)function.
• Information:Displaythemonitorinformation.
• All Reset:SelectYEStorevertallsettingstothefactorydefault
mode.