User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.6 Advanced menu
- 3.6.1 Platform Misc Configuration
- 3.6.2 CPU Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 PCH Configuration
- 3.6.5 PCH Storage Configuration
- 3.6.6 PCH-FW Configuration
- 3.6.7 Onboard Devices Configuration
- 3.6.8 APM Configuration
- 3.6.9 PCI Subsystem Configuration
- 3.6.10 USB Configuration
- 3.6.11 Network Stack Configuration
- 3.6.12 HDD/SSD SMART Information
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Appendix
ROG STRIX B360-I GAMING
1-13
Chapter 1
5. USB 2.0 connectors (10-1 pin USB910)
This connector is for USB 2.0 ports. Connect the USB module cable to this connector,
then install the module to a slot opening at the back of the system chassis. This USB
connector complies with USB 2.0 specication that supports up to 480 Mb/s connection
speed.
ROG STRIX B360-I GAMING USB2.0 connector
USB910
PIN 1
USB+5V
USB_P10-
USB_P10+
GND
NC
USB+5V
USB_P9-
USB_P9+
GND
DO NOT connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
The USB 2.0 module is purchased separately.
6. Thermal sensor connector (2-pin T_SENSOR)
This connector is for the thermistor cable that monitors the temperature of the devices
and the critical components inside the motherboard. Connect the thermistor cable
and place the sensor on the device or the motherboard’s component to detect its
temperature.
PIN 1
T_SENSOR
SENSOR IN
GND
ROG STRIX B360-I GAMING T_SENSOR connector