User's Manual
Table Of Contents
- 1.1 Knowing BIOS
- 1.2 BIOS setup program
- 1.3 My Favorites
- 1.4 Main menu
- 1.5 Ai Tweaker menu
- 1.6 Advanced menu
- 1.6.1 Platform Misc Configuration
- 1.6.2 CPU Configuration
- 1.6.3 System Agent (SA) Configuration
- 1.6.4 PCH Configuration
- 1.6.5 PCH Storage Configuration
- 1.6.6 PCH-FW Configuration
- 1.6.7 Onboard Devices Configuration
- 1.6.8 APM Configuration
- 1.6.9 USB Configuration
- 1.6.10 Network Stack Configuration
- 1.6.11 HDD/SSD SMART Information
- 1.6.12 Intel(R) Ethernet Connection (7) I219-V - 88:88:88:88:87:88
- 1.7 Monitor menu
- 1.8 Boot menu
- 1.9 Tool menu
- 1.10 Exit menu
- 1.11 Updating BIOS

ROG STRIX B360-F GAMING BIOS Manual
27
The following item appears only when you set CPU VRM Switching Frequency to
[Manual].
Fixed CPU VRM Switching Frequency (KHz)
This item allows you to set a higher frequency for a quicker transient
response speed. Use the <+> or <-> to adjust the value. The values range
from 250 KHz to 500 KHz with an interval of 50 KHz.
Do not remove the thermal module when the manual mode is selected. The thermal
conditions should be monitored.
CPU Power Duty Control
This item allows you to set the duty cycle of each VRM phase based upon current and/
or temperature.
[T.Probe] Sets the buck controller to balance VRM FET temperatures.
[Extreme] Sets the buck controller to balance per phase current.
DO NOT remove the thermal module. The thermal conditions should be monitored.
CPU Power Phase Control
This item allows you to set the power phase control of the CPU.
[Auto] Automatically set the phase control mode.
[Standard] The phase control will be based on the CPU command.
[Extreme] Set to the full phase mode.
DO NOT remove the thermal module when setting this item to [Extreme]. The thermal
conditions should be monitored.
CPU VRM Thermal Control
Disable this item to increase the temperature limit of the CPU VRM.
Conguration options: [Auto] [Disabled] [Enabled]
DO NOT remove the thermal module. The thermal conditions should be monitored.
Internal CPU Power Management
The subitems in this menu allow you to set the CPU ratio and features.
Intel(R) SpeedStep(tm)
Allows the operating system to dynamically adjust the processor voltage and cores
frequency to decrease the average power consumption and decrease average heat
production.
Conguration options: [Auto] [Disabled] [Enabled]
Turbo Mode
Allows you to enable your processor cores to run faster than the base operating
frequency when it is below power, current and specication limit.
Conguration options: [Disabled] [Enabled]