User's Manual

107
Steering Trigger Condition
This set of controls sets the criteria to initiate band steering.
• BandwidthUtilization
When bandwidth use exceeds this percentage, steering will
be initiated. Broadcom's documentation does not say how
utilization is measured.
• EnableLoadBalance
This controls load balancing. Broadcom's documentation does
not indicate how balancing is done.
• RSSI
If the received signal level of any associated client meets this
criteria, steering will be triggered.
• PHYRateLess/PHYRateGreater
These controls determine STA link rates that trigger band
steering.
• VHT
This controls determines how 802.11ac and non-ac clients are
handled.
• ALL (default) means any type of client can trigger steering.
• AC only means a client must support 802.11ac to trigger
steering.
• Not-allowed means only non-802.11ac clients will trigger
steering, i.e. 802.11a/b/g/n.