User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 Power Management
- 3.3.7 PCI Express Configuration
- 3.3.8 AMT Configuration
- 3.3.9 Super IO Configuration
- 3.3.10 Serial Console Redirection
- 3.3.11 SATA Configuration
- 3.3.12 VMD setup menu
- 3.3.13 Network Stack Configuration
- 3.3.14 USB Configuration
- 3.3.15 NVMe Configuration
- 3.3.16 Onboard Devices Configuration
- 3.3.17 Miscellaneous
- 3.3.18 APM Configuration
- 3.3.19 EZ-Flash
- 3.3.20 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
3-8
Q670EI-IM-A
Configuration options: [Disabled] [Enabled]
End Of Post Message
Allows you to enable or disable End of Post message sent to ME.
Configuration options: [Disabled] [Send in DXE]
Secure Erase Configuration
Secure Erase mode
Allows you to change Secure Erase module behavior.
Configuration options: [Simulated] [Real]
[Simulated] Performs SE flow without erasing SSD.
[Real] Erases SSD.
Force Secure Erase
Allows you to force Secure Erase on next boot.
Configuration options: [Disabled] [Enabled]
3.3.9 Super IO Configuration
Serial Port 1 Configuration
This item allows you to set parameters of Serial Port 1 (COMA).
Serial Port
Allows you to enable or disable the serial port (COM).
Configuration options: [Disabled] [Enabled]
COM1 Control
Allows you to select COM1 mode.
Configuration options: [RS232] [RS422] [RS485]
Serial Port 2 Configuration
This item allows you to set parameters of Serial Port 2 (COMB).
Serial Port
Allows you to enable or disable the serial port (COM).
Configuration options: [Disabled] [Enabled]
COM2 Control
Allows you to select COM2 mode.
Configuration options: [RS232] [RS422] [RS485]
Serial Port 3 Configuration
This item allows you to set parameters of Serial Port 3 (COMC).
Serial Port
Allows you to enable or disable the serial port (COM).Conīæguration options:
[Disabled] [Enabled]
Serial Port 4 Configuration
This item allows you to set parameters of Serial Port 4 (COMD).