User's Manual
Table Of Contents
- Chapter 1 Product Overview
- Chapter 2: Motherboard information
- Chapter 3: BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 Power Management
- 3.3.6 PCI Express Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 VMD setup menu
- 3.3.11 Network Stack Configuration
- 3.3.12 USB Configuration
- 3.3.13 NVMe Configuration
- 3.3.14 Onboard Devices Configuration
- 3.3.15 APM Configuration
- 3.3.16 EZ-Flash
- 3.3.17 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
3-16
Q670EA-IM-A
I2C0 Controller
If given device is Function 0 PSF disabling is skipped. PSF default will remain and
device PCI CFG Space will still be visible. This is needed to allow PCI enumerator
access functions above 0 in a multifunction device. The following devices depend
on each other: I2C0 and I2C1, 2, 3; UART0 and UART1, SPIO, 1; UART2 and
I2C4, 5. UART 0 (00:30:00) cannot be disabled when: 1. Child device is enabled
like CNVi Bluetooth (\_SB.PC00.UA00.BTH0). UART 0 (00:30:00) cannot be
enabled when: 1. I2S Audio codec is enabled (\_SB.PC00.I2C0.HDAC).
Configuration options: [Disabled] [Enabled]
CPU PCIEX16 switch function
Configuration options: [2x8] [1x16] [AUTO]
3.3.15 APM Configuration
This item allows you to configure APM (Advanced Power Management) settings.
ErP Ready
Allows BIOS to switch off some power at S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options will be switched off.
Configuration options: [Disabled] [Enabled]
Restore AC Power Loss
Allows you to select AC power state when power is re-applied after a power failure.
Configuration options: [S5 State] [S0 State]
Power On By PCIE/PCI
Allows you to enable or disable the Wake-on-LAN function of the onboard LAN
controller or other installed PCIe LAN cards.
Configuration options: [Disabled] [Enabled]
Power On By PS2
Configuration options: [Disabled] [Enabled]
Power On By Ring
Configuration options: [Disabled] [Enabled]
Power On By RTC
Configuration options: [Disabled] [Enabled]
The following items appear when you set Power On By RTC to [Single event]
or [Daily event].
Wake up hour
Allows you to enter a natural number within 0-23 for hour. For example, enter 3 for
3:00 am and 15 for 3:00 pm.