User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 PCI Express Configuration
- 3.3.7 AMT Configuration
- 3.3.8 CSM Configuration
- 3.3.9 Super IO Configuration
- 3.3.10 Serial Console Redirection
- 3.3.11 SATA And RST Configuration
- 3.3.12 Network Stack Configuration
- 3.3.13 USB Configuration
- 3.3.14 NVMe Configuration
- 3.3.15 Onboard Devices Configuration
- 3.3.16 EZ-Flash
- 3.3.17 APM Configuration
- 3.3.18 Watchdog Timer
- 3.3.19 Miscellaneous
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
2-23
Chapter 2: Motherboard information
NOTE: The serial port cables are purchased separately.
17. Serial port connectors (10-1 pin COM2, COM3, COM4, COM5)
These connectors are for serial (COM) ports. Connect the serial port cables
to these connectors, then install the module to a slot opening at the back of
the system chassis.
Ring
RTS#
GND
TXD
DCD#
CTS#
DSR#
DTR#
RXD
COM3
COM4
COM5
COM2
A
B
C
D
A
B
C
D
PIN 1
Connector type
BOX header 2x5p, K10, 2.0mm pitch
18. Flat panel display brightness connector (5-pin LCD_BLKT_PANEL)
This connector is for the LCD panel brightness controls.
+12V
GND
LCD_ENABKLT_CN
H_LCD_BL_PWM_SW
+5V
PIN1
+12V
GND
LCD_ENABKLT_CN
NC
+5V
PIN1
LCD_BLKT_PANEL
LVDS Signal eDP Signal
Connector type
WAFER 6p, 2.0mm pitch