User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 AMT Configuration
- 3.3.7 CSM Configuration
- 3.3.8 Super IO Configuration
- 3.3.9 Serial Console Redirection
- 3.3.10 SATA And RST Configuration
- 3.3.11 Network Stack Configuration
- 3.3.12 USB Configuration
- 3.3.13 NVMe Configuration
- 3.3.14 Onboard Devices Configuration
- 3.3.15 EZ-Flash
- 3.3.16 APM Configuration
- 3.3.17 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
1-3
Chapter 1: General information
Internal I/O ports
5 x COM Port headers (1 x RS232/422/485, 5 x RS232)
1 x USB 3.2 Gen 1 header supports additional 2 USB 3.2 Gen 1
ports
1 x USB 2.0 vertical connector
2 x USB 2.0 headers support additional 4 USB 2.0 ports
1 x CPU Fan header with PWM mode
3 x Chassis Fan headers with PWM mode
1 x Chassis Intrusion header
1 x Front Panel Audio header (AAFP)
1 x System Panel header
1 x Clear CMOS header
1 x Speaker header
1 x LPC Debug header
1 x LPT header
1 x LAN LED header
1 x Buzzer
1 x S/PDIF header
1 x AT/ATX mode selection jumper
1 x 24-pin ATX power connector
1 x 8-pin ATX power connector
1 x WDT Enable header
1 x TPM header
1 x SMBDATA_SW selection jumper
1 x SMBCLK_SW selection jumper
4 x SATA 6.0Gb/s ports
1 x COM Ring/+5V/+12V selection jumper
1 x M.2 M Key, type 2242/2260/2280 (PCIe x4 / SATA mode)
Manageability
WfM 2.0, DMI 2.0, WOL by PME, GPIO
Watch dog timer
Yes
Power requirement
AT/ATX mode
Operation
Temperature
0~60°C
Non-Operation
Temperature
-40~85°C
(continued on the next page)
Specifications