User Manual

3-15
Chapter 3: BIOS setup
Conguration options: [Disabled] [Enabled]
Intel LAN1 OPROM
Allows you to launch Intel PXE OPROM. Conguration options: [Disabled] [Enabled]
LAN2 RTL8111H
Conguration options: [Disabled] [Enabled]
Realtek LAN2 OPROM
Allows you to launch Realtek PXE OPROM. Conguration options: [Disabled]
[Enabled]
M.2 NVME (M-Key)
M.2 M-KEY (PCIE)
Allows you to enable or disable the M.2 M-Key PCIE port. Conguration options:
[Disabled] [Enabled]
3.3.14 EZ-Flash
This item allows you to enter EZ-Flash mode. After you press <Enter>, a
conrmation message appears. Use the left/right arrow key to select between [Yes]
or [No], then press <Enter> to conrm your choice.
3.3.15 APM Configuration
This item allows you to congure APM (Advanced Power Management) settings.
ErP Ready
Allows BIOS to switch off some power at S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options will be switched off.
Conguration options: [Disabled] [Enabled]
Restore AC Power Loss
Allows you to select AC power state when power is re-applied after a power failure.
Conguration options: [S5 State] [S0 State]
Power On By PCIE
Allows you to enable or disable the Wake-on-LAN function of the onboard LAN
controller or other installed PCIe LAN cards. Conguration options: [Disabled]
[Enabled]
Power On By PCI
Allows you to enable or disable the Wake-on-LAN function by installed PCI
devices. Conguration options: [Disabled] [Enabled]
Power On By PS2
Allows you to enable or disable the Wake-on-LAN function by installed PS2
devices. Conguration options: [Disabled] [Enabled]