User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Ai Tweaker menu
- 3.3.1 CPU Power Enhancement
- 3.3.2 CPU Core Ratio
- 3.3.3 DRAM Odd Ratio Mode
- 3.3.4 DRAM Frequency
- 3.3.5 Power-saving & Performance Mode
- 3.3.6 DRAM Timing Control
- 3.3.7 DIGI+ VRM
- 3.3.8 Internal CPU Power Management
- 3.3.9 CPU Core/Cache Current Limit Max.
- 3.3.10 CPU Graphics Current Limit
- 3.3.11 Min. CPU Cache Ratio
- 3.3.12 Max. CPU Cache Ratio
- 3.3.13 Max. CPU Graphics Ratio
- 3.3.14 DRAM Voltage
- 3.3.15 DRAM REF Voltage Control
- 3.4 Advanced menu
- 3.4.1 Platform Misc Configuration
- 3.4.2 CPU Configuration
- 3.4.3 System Agent (SA) Configuration
- 3.4.4 PCH Configuration
- 3.4.5 PCH Storage Configuration
- 3.4.6 PCH-FW Configuration
- 3.4.7 AMT Configuration
- 3.4.8 Trusted Computing
- 3.4.9 Onboard Devices Configuration
- 3.4.10 APM Configuration
- 3.4.11 Serial Port Console Redirection
- 3.4.12 Intel TXT Information
- 3.4.13 PCI Subsystem Settings
- 3.4.14 USB Configuration
- 3.4.15 Network Stack Configuration
- 3.4.16 NVMe Configuration
- 3.4.17 HDD Secure Erase
- 3.4.18 HDD/SSD SMART Information
- 3.5 Monitor menu
- 3.6 Boot menu
- 3.7 Tool menu
- 3.8 Exit menu
- BIOS setup
- Appendix
2-11
Chapter 2: Motherboard information
3. Intel
®
ME jumper (3-pin DIS_ME)
This jumper allows you to enable or disable the Intel
®
ME function. Set this
jumper to pins 1-2 to enable (default) the Intel
®
ME function and to pins 2-3 to
disable it.
21
2 3
DIS_ME
Disable intel
ME function
Normal
(Default)
Connector type
HEADER 1x3p, 2.54mm pitch, S/T
2. Chassis intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The
chassis intrusion sensor or switch sends a low-level signal to this connector
when a chassis component is installed. The signal is then generated as a chassis
intrusion event.
PIN 1
+5VSB_MB
Chassis Signal
GND
CHASSIS
Connector type
HEADER 4p, K2, 2.54mm pitch