Specifications
4-64-6
4-64-6
4-6
Chapter 4: Motherboard infoChapter 4: Motherboard info
Chapter 4: Motherboard infoChapter 4: Motherboard info
Chapter 4: Motherboard info
2.2.
2.2.
2.
Serial ATA connectors (7-pin SATA1, SATA2)Serial ATA connectors (7-pin SATA1, SATA2)
Serial ATA connectors (7-pin SATA1, SATA2)Serial ATA connectors (7-pin SATA1, SATA2)
Serial ATA connectors (7-pin SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA
hard disk drives.
3.3.
3.3.
3.
CPU and Chassis fan connectorsCPU and Chassis fan connectors
CPU and Chassis fan connectorsCPU and Chassis fan connectors
CPU and Chassis fan connectors
(4-pin CPU_FAN, 3-pin CHA_FAN)(4-pin CPU_FAN, 3-pin CHA_FAN)
(4-pin CPU_FAN, 3-pin CHA_FAN)(4-pin CPU_FAN, 3-pin CHA_FAN)
(4-pin CPU_FAN, 3-pin CHA_FAN)
The fan connectors support cooling fans of 350 mA~740 mA (8.88 W
max.) or a total of 1 A~2.22 A (26.64 W max.) at +12V. Connect the
fan cables to the fan connectors on the motherboard, making sure that
the black wire of each cable matches the ground pin of the connector.
Important notes on Serial ATAImportant notes on Serial ATA
Important notes on Serial ATAImportant notes on Serial ATA
Important notes on Serial ATA
• You must install Windows
®
2000 Service Pack 4 or the Windows
®
XP
Service Pack1 before using Serial ATA hard disk drives.
• When using the connectors in standard IDE mode, you can connect the
primary (boot) hard disk drive to any of the SATA connectors.
Do not forget to connect the fan cables to the fan connectors.
Insufficient air flow inside the system may damage the motherboard
components. These are not jumpers! Do not place jumper caps on the
fan connectors!
®
SATA connectors
SATA2
GND
RSA T A_TXP2
RSA T A_TXN2
GND
RSA T A_RXP2
RSA T A_RXN2
GND
SATA1
GND
RSA T A_TXP1
RSA T A_TXN1
GND
RSA T A_RXP1
RSA T A_RXN1
GND
®
Fan connectors
CPU_FANCHA_FAN
GND
Rotation
+12V
GND
Rotation
+12V