Setup Guide

9
E
Installation
Installing on a stand
(Standing position)
Placement on the variable stand
Placetheunitonthesuppliedvariablestand.
Caution
• Thevariablestandisdesignedforplacementoftheunitin
thelandscapeorientation.Itcannotbeusedfortheportrait
orientation.
• Whenconnectingthestand,spreadasoftclothonastable
levelsurfacesuchasadesk,andgentlyplacethemonitor
onitwiththescreenfacingdown.
• ApplyingexcessivepressuretotheLCDpanelwithyour
handsmayresultindamagetotheunit.
• Becarefulnottogetyourngerscaughtwhenadjustingthe
angle.Thereisariskofinjury.
1. Place the variable stand on the rear of the monitor,
insertthexingscrewsandtightenbyhandtoposition
the stand.
2. Securelytightenthexingscrewsusingthesupplied
hexagonalwrench.
3. Place the monitor in the standing position, and adjust
the angle of the stand.
 Holdthetopofthedisplaywithonehandsothatitdoesnot
fallover,holdtherearlegofthestandwithyourotherhand,
andadjusttheangleofthestand.
 Thelegscanextendabout20to75degreesinrelationto
theatsurface.
20°
75°