User Manual
Table Of Contents
- 1. Knowing BIOS
- 2. BIOS setup program
- 3. My Favorites
- 4. Main menu
- 5. Ai Tweaker menu
- 6. Advanced menu
- 6.1 Platform Misc Configuration
- 6.2 CPU Configuration
- 6.3 System Agent (SA) Configuration
- 6.4 PCH Configuration
- 6.5 PCH Storage Configuration
- 6.6 PCH-FW Configuration
- 6.7 Thunderbolt(TM) Configuration
- 6.8 Trusted Computing
- 6.9 PCI Subsystem Settings
- 6.10 USB Configuration
- 6.11 Network Stack Configuration
- 6.12 NVMe Configuration
- 6.13 HDD/SSD SMART Information
- 6.14 APM Configuration
- 6.15 Onboard Devices Configuration
- 6.16 Intel(R) Rapid Storage Technology
- 7. Monitor menu
- 8. Boot menu
- 9. Tool menu
- 10. Exit menu
- 11. Updating BIOS
PRIME / ProArt / TUF GAMING Intel 700 Series BIOS Manual
33
tREFIX9
Configuration options: [Auto] [0] - [255]
Ref Interval
Configuration options: [Auto] [0] - [8191]
tXPDLL
Configuration options: [Auto] [0] - [127]
tXP
Configuration options: [Auto] [0] - [127]
tPPD
Configuration options: [Auto] [0] - [15]
tCCD_L_tDLLK
Configuration options: [Auto] [0] - [15]
Misc.
MRC Fast Boot
Allows you to enable or disable the MRC fast boot.
Configuration options: [Disabled] [Enabled]
MCH Full Check
Enable this item to enhance the system stability. Setting this item to
[Disabled] may
enhance the DRAM overclocking capability.
Configuration options: [Auto] [Enabled] [Disabled]
Mem Over Clock Fail Count
Configuration options: [Auto] [1] - [255]
Training Profile
Allows you to select the DIMM training profile.
Configuration options: [Auto] [Standard Profile] [ASUS User Profile]
RxDfe
Allows you to set the DFE on SOC Rx.
Configuration options: [Auto] [Enabled] [Disabled]
Mrc Training Loop Count
Allows you to set the exponential number of loops to run the test.
Configuration options: [Auto] [0] - [32]
DRAM CLK Period
Allows you to set the DRAM clock period.
Configuration options: [Auto] [0] - [161]
Dll_bwsel
Try range of 22+ for OC.
Configuration options: [Auto] [0] - [63]
Controller 0, Channel 0 Control
Allows you to enable or disable Controller 0, Channel 0.
Configuration options: [Enabled] [Disabled]