User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- 2.1 Building your PC system
- 2.1.1 CPU installation
- 2.1.2 Cooling system installation
- 2.1.3 DIMM installation
- 2.1.4 M.2 installation
- 2.1.5 Motherboard installation
- 2.1.6 ATX power connection
- 2.1.7 SATA device connection
- 2.1.8 Front I/O connector
- 2.1.9 Expansion card installation
- 2.1.10 Thunderbolt™ 4 monitor connection
- 2.1.11 Wi-Fi moving antenna installation
- 2.2 BIOS update utility
- 2.3 Motherboard rear and audio connections
- 2.4 Starting up for the first time
- 2.5 Turning off the computer
- 2.1 Building your PC system
- Chapter 3: BIOS and RAID Support
- Appendix
ProArt Z690-CREATOR WIFI
2-11
Chapter 2
For 2242, 2260 length
A. (optional) Remove the M.2 rubber pad.
Follow this step only if you wish to install an M.2 to type 2242.
B. Install the M.2 Q-Latch to the M.2 length screw hole you wish to install
your M.2 to.
C. Rotate and adjust the M.2 Q-latch so that the handle points away
from the M.2 slot.
D. Install your M.2 to the M.2 slot.
E. Rotate the M.2 Q-Latch clockwise to secure the M.2 in place.