User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- 2.1 Building your PC system
- 2.1.1 CPU installation
- 2.1.2 Cooling system installation
- 2.1.3 DIMM installation
- 2.1.4 M.2 installation
- 2.1.5 Motherboard installation
- 2.1.6 ATX power connection
- 2.1.7 SATA device connection
- 2.1.8 Front I/O connector
- 2.1.9 Expansion card installation
- 2.1.10 Thunderbolt™ 4 monitor connection
- 2.1.11 Wi-Fi moving antenna installation
- 2.2 BIOS update utility
- 2.3 Motherboard rear and audio connections
- 2.4 Starting up for the first time
- 2.5 Turning off the computer
- 2.1 Building your PC system
- Chapter 3: BIOS and RAID Support
- Appendix
2-10
Chapter 2: Basic Installation
Chapter 2
OPTIONAL
• To install an M.2 to M.2_2 and M.2_4 slot
For 2280 length
A. (optional) Install the bundled M.2 rubber pad if you are installing a
single sided M.2 storage device. DO NOT install the bundled M.2
rubber pads when installing a double-sided M.2 storage device. The
rubber pad installed by default is compatible with double sided M.2
storage devices.
B. Rotate and adjust the M.2 Q-latch so that the handle points away
from the M.2 slot.
C. Install your M.2 to the M.2 slot.
D. Rotate the M.2 Q-Latch clockwise to secure the M.2 in place.