User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- 2.1 Building your PC system
- 2.1.1 CPU installation
- 2.1.2 Cooling system installation
- 2.1.3 DIMM installation
- 2.1.4 M.2 installation
- 2.1.5 Motherboard installation
- 2.1.6 ATX power connection
- 2.1.7 SATA device connection
- 2.1.8 Front I/O connector
- 2.1.9 Expansion card installation
- 2.1.10 Thunderbolt™ 4 monitor connection
- 2.1.11 Wi-Fi moving antenna installation
- 2.2 BIOS update utility
- 2.3 Motherboard rear and audio connections
- 2.4 Starting up for the first time
- 2.5 Turning off the computer
- 2.1 Building your PC system
- Chapter 3: BIOS and RAID Support
- Appendix
2-8
Chapter 2: Basic Installation
Chapter 2
• To install an M.2 to M.2_1 and M.2_3 slot
For 2280, 22110 length
A. (optional) Remove the pre-installed removable M.2 Q-Latch screw at
the 2280 length screw hole.
Follow step A only when you wish to install an 22110 length M.2.
B. (optional) Install the bundled M.2 rubber pad if you are installing a
single sided M.2 storage device. DO NOT install the bundled M.2
rubber pads when installing a double-sided M.2 storage device. The
rubber pad installed by default is compatible with double sided M.2
storage devices.
C. Rotate and adjust the M.2 Q-latch so that the handle points away
from the M.2 slot.
D. Install your M.2 to the M.2 slot.
E. Rotate the M.2 Q-Latch clockwise to secure the M.2 in place.
OPTIONAL