User’s Manual

ProArt Z690-CREATOR WIFI
2-7
Chapter 2
2.1.4 M.2 installation
Supported M.2 type varies per motherboard.
• The illustrations only show the installation steps for a single M.2 slot, the steps are
the same for the other M.2 slots if you wish to install an M.2 to another M.2 slot.
• Use a Phillips screwdriver when removing or installing the screws or screw stands
mentioned in this section.
• If the thermal pad on the M.2 heatsink becomes damaged and needs to replaced, we
recommend replacing it with a thermal pad with a thickness of 1.25mm.
• The M.2 is purchased separately.
1. Loosen the screws from the M.2 heatsinks.
2. Remove the cushioning from the M.2_1 heatsink (top M.2 heatsink), then lift and
remove the heatsinks.
1
1
1
1
1
2
1
2
2