User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- 2.1 Building your PC system
- 2.1.1 CPU installation
- 2.1.2 Cooling system installation
- 2.1.3 DIMM installation
- 2.1.4 M.2 installation
- 2.1.5 Motherboard installation
- 2.1.6 ATX power connection
- 2.1.7 SATA device connection
- 2.1.8 Front I/O connector
- 2.1.9 Expansion card installation
- 2.1.10 USB4® monitor connection
- 2.1.11 Wi-Fi moving antenna installation
- 2.2 BIOS update utility
- 2.3 Motherboard rear and audio connections
- 2.4 Starting up for the first time
- 2.5 Turning off the computer
- 2.1 Building your PC system
- Chapter 3: BIOS and RAID Support
- Appendix
ProArt X670E-CREATOR WIFI
2-21
Chapter 2
Using the PCIe Slot Q-Release
The PCIEX16_1 slot comes with a PCIe Slot Q-Release button allowing you to easily
remove an expansion card installed to this PCIe slot, even when the expansion card may be
blocking the PCIe push-latch, such as a graphics card.
To release an expansion card using the PCIe Slot Q-Release:
Slightly lift the expansion card with one hand and press the PCIe Slot Q-Release button with
the other hand. This should release the expansion card so that you can remove it with ease.
The illustration below is for reference only. The motherboard and PCIe Slot Q-Release
button may differ between models, but the steps for using the PCIe Slot Q-Release remain
the same.