User’s Manual
Table Of Contents
1-7
19. Thermal Sensor header
The Thermal Sensor header allows you to connect a sensor to monitor the temperature of the
devices and the critical components inside the motherboard. Connect the thermal sensor and
place it on the device or the motherboard’s component to detect its temperature.
The thermal sensor is purchased separately.
20. Thunderbolt™ header
The Thunderbolt™ header allows you to connect an add-on Thunderbolt™
I/O card that supports Intel
®
’s Thunderbolt™ Technology, allowing you to
connect Thunderbolt™-enabled devices to form a daisy chain-conguration.
• The add-on Thunderbolt™ I/O card and Thunderbolt™ cables are
purchased separately.
• Please visit the ofcial website of your purchased Thunderbolt card
for more details on compatibility.
The Thunderbolt™ card can only be used when installed to the
PCIEX16(G4) slot. Ensure to install your Thunderbolt™ card to the
PCIEX16(G4) slot.
21. Q-LEDs
The Q-LEDs check key components (CPU, DRAM, VGA, and booting devices) during the
motherboard booting process. If an error is found, the critical component’s LED stays lit up
until the problem is solved.
The Q-LEDs provide the most probable cause of an error code as a starting point for
troubleshooting. The actual cause may vary from case to case.
22. 8-pin Power Plug LED
The 8-pin Power Plug LED lights up to indicate that the 8-pin power plug is not connected.
PIN 1
FORCE_PWR
CIO_PLUG_EVENT
SLP_S3#
SLP_S5#
GND
RTD3_SW
I2C_SCL
I2C_SDA
I2C_IRQ#
RTD3_POWER_EN
S_SLP_S0#_IDLE
PERST_N
WAKE#
TB_HEADER
ProArt B760-CREATOR