User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.15 BSOD Capture
- 5.10.16 Error Codes
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
4-14 Chapter 4: Device Information
4.7 Control (software)
• This item will not be available if your device is not logged into an OS
environment.
• If the below settings have not previously been configured using ASUS
Control Center Express, the default value of “Not config” will be displayed.
• Use the Mission Center to check if the task was completed successfully.
Refer to the
Mission Center
section for more information.
This item allows you to configure system, USB, power, and boot options. This item
is software controlled and values may differ with the hardware version. Please
refer to the following for information on
Hardware
mode:
• DASH devices:
5.7.3 Control
• RTL8117 devices:
5.8.3 Control
• vPro devices:
5.9.2 Control
• BMC devices:
5.9.3 Control
Enable/Disable Regedit
Enable or disable the Windows Registry Editor.
USB Storage Device
Enable or disable the USB port, or set it to Read Only.
Restart Computer
Restart the client device.
Power On
Power on the client device.
If Wake on LAN is supported on the client device, the
client device can be powered on using this function
when the client device is powered off.
Power Off
Power off the client device.
Fast Startup
Enable or disable fast startup for the client device.
Windows Update
Enable or disable Windows Update for the client device.
Set Management
Controller
Set the IP address of the vPro management controller.
This function is only supported if the client device
supports vPro remote management.