User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.15 BSOD Capture
- 5.10.16 Error Codes
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
2-24 Chapter 2: Main Menu Overview
•
Click on the
X
next to the task progress bar to delete a completed task.
Only completed tasks can be deleted, tasks that are still pending and
ongoing tasks cannot be deleted until they are completed.
• Tasks that are split up into steps can also be completed through the
Mission Center. For example a task that restarts the client device after
BIOS update; you can restart the client device through the Mission Center
once the BIOS update step has been completed.
• The Mission Center will record current ongoing tasks on the ASUS Control
Center Express main server, if the ASUS Control Center Express main
server is closed and restarted, the mission center’s tasks will be reset and
only record the ongoing tasks once the ASUS Control Center Express
main server has restarted.
2.4.2 Mission Center tasks
The table below lists the tasks you can view on the Mission Center.
Power Control
Power off/power on/restart computer
Security and Boot
Registry Tool
Enable/disable regedit
USB Control
Enable/disable USB control
Set USB to read only
Fast Startup
Enable/disable fast startup
Software Management
Software Dispatch
Software Blacklist
Installer
Smart BIOS
BIOS update
Client Agent Updater
Update client device’s agent
Settings Migrator
Migrate server settings
Main Server Settings
Agent deployment
OOB Control*
Power Control
Watchdog
BIOS
Account Management
System
KVM
USB Redirection
Firmware Update
Trust Zone
Certificate
System Trap Alert
IPMI
Settings
Configuration
* These functions are only available on motherboards that support remote management controllers.