User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.15 BSOD Capture
- 5.10.16 Error Codes
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-163ASUS Control Center Express
5.10.16 Error Codes
0x83100002
Client device does not support BMC.
0x83100003
Command invalid.
0x83100025
Client device must be powered off to clear CMOS.
0x83100026
Check if the SPI connector is connected to the IPMI TPM
connector on the motherboard.
0x83100033
Could not connect to the BMC web interface.
0x83100034
BMC login credentials incorrect.
0x83100006
Could not synchronize BMC functions. Check network
connectivity and try again. If this issue persists, shut down
the client device, disconnect the power, then restart the client
device.
0x831F4077
Could not log into BMC on the client device. Check if BMC is
working correctly on the client device or reenter BMC login
credentials and try again. If this issue persists, shut down the
client device, disconnect the power, then restart the client
device.
0x831F4038
No response received from BMC on the client device. If this
issue persists, shut down the client device, disconnect the
power, then restart the client device.