User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.15 BSOD Capture
- 5.10.16 Error Codes
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-155ASUS Control Center Express
PSU Redundancy
This item allows you to configure PSU redundancy settings, allowing you to focus
system power consumption on one PSU device for improved power efficiency.
PSU Redundancy Enable or disable PSU Redundancy
To use PSU Redundancy, the PSU PM_BUS header and SMART_PSU switch
jumper must be activated.
Service Web Configuration
This item allows you to configure the Web service.
Active Enable or disable the Web service.
Interface Name Select the interface used for the Web service.
Secure Port
Enter the secure port used for the Web service.
(default: 443)
Timeout
Configure the session timeout value in multiples of 60
seconds between 300 to 1800 seconds
Maximum Sessions Shows the maximum number of allowed sessions.
Service KVM Configuration
This item allows you to configure the KVM service.
Active Enable or disable the KVM service.
Interface Name Select the interface used for the KVM service.
Secure Port
Enter the secure port used for the KVM service.
(default: 443)
Timeout
Configure the session timeout value in multiples of 60
seconds between 300 to 1800 seconds
Maximum Sessions Shows the maximum number of allowed sessions.