User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.15 BSOD Capture
- 5.10.16 Error Codes
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-152 Chapter 5: Management Functions
Video Remote Storage Settings
This item allows you to configure video remote storage settings.
Record Video to Remote
Server
Enable or disable Remote Video support.
Maximum Dumps Set the maximum dump limit between 1 and 100.
Maximum Duration
Set the maximum duration between 1 and 3600
seconds.
Maximum Size
Set the maximum size of dumps between 1 and 500
MB.
Server Address
Set the IP address of the remote server where the
remote videos will be stored.
Path in Server Set the path of the media on the remote server.
Share Type Set the share type to NFS or Samba (CIFS).
Domain Name* Enter the domain name of the remote server.
Username* Enter the username for the remote server.
Password*
Enter the password for the remote server.
Settings marked with an asterisk (*) are only available when the checkbox for
CIFS
is selected.
Pre-Event Video Recording Settings
This item allows you to configure Pre-Event video recording settings.
To enable Pre-Event Video Recording, please go to the
Video Trigger
Settings
section.
Video Quality Select the video quality.
Compression Mode Select the compression mode.
Frames Per Second Select the frames per second (FPS).
Video Duration Select the duration of the video recording in seconds.