User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.15 BSOD Capture
- 5.10.16 Error Codes
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-147ASUS Control Center Express
Advanced Log Settings
This item allows you to set advanced log settings for the event log.
System Log
Enable
System Log
to view all system events. Entries
can be filtered based on their classification levels.
Local Log
Check this item to save the logs locally on the BMC
device.
Remote Log
Check this item to save the logs in a remote machine.
Port Type
Set the port type to TCP or UDP.
File Size
Set the size of the local log file in bytes between 3 and
65535.
Rotate Count
When logged information exceeds the specified file size,
old log information will automatically be rotated to backup
based on the rotate count value.
• Rotate count value must be 0 or 1.
• If the rotate count is 0, the old log
information will be permanently cleared
each time.
Remote Log Server
Set the remote server address for the system log.
Remote Server Port
Set the port number for the system log.
Enable Audit Log
Enable this item to view all audit events for the client
device.