User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.15 BSOD Capture
- 5.10.16 Error Codes
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-101ASUS Control Center Express
5.9.3 Remote Desktop
The
Remote Desktop
function allows you to control a vPro client device through
KVM. This is useful for remotely monitoring and repairing the client device, should
the client device’s OS encounter an error.
• Availability of certain functions may vary depending on vPro support
and ME version. Remote desktop is not supported by Intel Standard
Manageability (ISM).
• If the client device is operating from the Intel MEBx, you will not be able to
connect using KVM.
• The device will not be able to enter the Intel MEBx settings page if the
client device was restarted whilst using KVM.
• When using the KVM remote desktop function of a vPro device, the border
of the client device screen will flash red and yellow to indicate that the
client device is currently running the KVM remote desktop function.
Setting up KVM before using Remote Desktop
Before using the Out-of-band Management Remote Desktop function for the first
time, ensure that KVM is enabled. On the Management Control Information page
of the vPro device, click
Control
, then click the drop down menu of the
Enable/
Disable KVM
field and select
Enable
.
To disable KVM, select the
Disable
option and restart the client device.